Spin on oil filter adaptor

[Bert Poliakoff]

Check the for sale section. I have spin on oil filter adaptors for the M30 engines

 

[billpatterson]

Hi Bert
Do you still stock/make these?

Regards,
Bill

 

[Bert Poliakoff]

I have a few on hand depending on which one you need. What size is your existing canister? It will either be 4" or 3.5" depending on your motor. If 3.5" does the retaining bolt go through the bottom or the top? I have a few of the 3.5" ones that are for a bottom bolt. However, I can get some more made if different as I can use a few to have on the shelf

 

[billpatterson]

Hi Bert,
Thanks for the reply!
Ok...I will measure mine. When you say 3.5", are you referring to the diameter of the filter's can?

Regards,
Bill

 

[Bert Poliakoff]

Yes. The diameter of the can will either be 3.5" or 4"

 

[billpatterson]

Hi Bert
My oil filter can is 4" and bolts on from below. What do they cost?

Regards,
Bill

 

[Bert Poliakoff]

Bill I am out of those. My machinist has not being responsive to me I will go over to his shop and get back to you and let you know what is going on cost is $150 shipped so before I go let me know if you want it

 

[billpatterson]

Hi Bert
I think I should pass at this time. I need to consider the higher priorities for my project and allocate $ accordingly. Thank you though!!

Bill

 

[Bert Poliakoff]

Not a problem. I went to my machinist earlier and ordered a few to have on hand so you at least gave me a wake up call. If you ever want one, I am the only one that produces these for the 4" can Take care