Search results

  1. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Steve, I only painted the centers. These wheels already had like new silver paint -as original from Coupeking.
  2. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Project 75: Refresh the finish on the seat belts. In a prior life someone had covered the seat belt cable with the plastic corrugated jacketing for wire harnesses (image 0050.jpg). I am not fond of that material. The seat belt buzzer switch I will never use again. So it was off with the...
  3. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Project 74: Replace the missing anchor point / eyelet on the spare tire well and spare mounting bracket inside the tire well. The PO's body shop did a fine job of blending in the new spare tire well. Unfortunately they did not install the original eyelet / tiedown on the outside of the well...
  4. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    This is the best aluminum polish I've found. No, beltline trim did not have any coating on it, hence the oxidation over time. Yes, I used a microfiber as shown in image 0022 above to apply the ceramic coating. I use the corner as you have to cut it off when it dries hard.
  5. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Occasionally you have to go backwards. Which I really try and avoid. In this case the rear bumper alignment was not perfect, the correct bumperette rubber covers had arrived along with the correct center seam chrome cover. All of this warranted dropping the bumper and reworking these items...
  6. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Project 73: Polish and Ceramic coat the belt line trim. All of the belt line trim on the car had been simply polished with no protection. After a few years the raw aluminum gets dull. I was not about to remove all of the trim, have it repolished and Cerikote it. So I took the decision to...
  7. paul cain

    Series 2 original leather seats Euro LHD

    This is an image of Patricia Mayer's seat -known original- with ~34k miles. Piped on upper and lower sections. 1974 U.S. Market 3.0 CS VIN no. 4330055
  8. paul cain

    Inspiration Photographs

    Extremely impressive effort. Few understand that so much of the quality on a beautiful paint job is done at this metal stage. This is a vivid example where few will appreciate the tight gap to the edge of the taillamp frame. Most shops would achieve this gap with more bondo. When it is...
  9. paul cain

    Inspiration Photographs

    Fjord. Fjord. Fjord.
  10. paul cain

    Need center wheel caps

    Make sure you look for E12 wheel caps, very different than the earlier '74 E9 wheel.
  11. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Project 72: Rebuild, clean, adjust and repair front door mechanisms. These are some of the replacement parts that are going in each door. The W&N clear plastic membrane with adhesive is the final step in buttoning up the door. This skin for some reason adds substantially to a quiet and...
  12. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Project 71: Restore the functionality of the Engine Compartment lamp A big thank you to @Stevehose for the link to Oil's bracket: https://oilsdesigngroup.com/product/support-for-hood-light-switch/ I rerouted the wiring in the hood, replaced the switch and installed the Oil's bracket. Then I...
  13. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Project 70: Install E28 Rear window lift motors, realign glass, new weatherstripping and adjustments The PO had simply reinstalled both original rear window lift mechanisms without cleaning or replacing the worn gaskets. Both new weatherstripping seals were installed on the inside and the...
  14. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Project 69 Install new under hood insulation. This is the W&N product with a very good die pattern to match the underhood cut outs. No trimming is required. This adhesive is extremely aggressive. You really need to be in the final position once the adhesive backing makes contact. Otherwise...
  15. paul cain

    Finishing School for a Fjord 3.0 CS / 100 projects to improve a Coupe / Countdown

    Project 68: Fabricate trunk carpeting with tool caddy Today was fabricating the trunk floor carpeting. This is a pattern for the US / Federalized E9. I am done with this pattern. If anyone needs to make the same trunk carpeting, the pattern is free to you. Just pay shipping. Carpet will...
  16. paul cain

    WTB E9 engine compartment tab for lamp switch

    Well.....That was easy! Thank you Steve!
  17. paul cain

    WTB E9 engine compartment tab for lamp switch

    Looking to purchase (1) of these tabs in the engine compartment that actuates the engine compartment lamp switch at closure. I believe it is common to the E3. See attached image.
  18. paul cain

    FS: (SOLD) Tan leather Seat Covers Fronts Only Pair (L 0303) Late 1974 Style $250 for the pair

    This is a set of lightly used leather seat covers in Tan leather (Code L 0303). These were installed by the prior owner of my current E9 project and had very few miles on them. They are of modest quality and the lower skirts have been re-dyed in a slightly darker shade of tan. First three...
  19. paul cain

    FPS 14 inch Alloys on BaT now / Link

    Looks to be a very nice set. Just saw it on BaT. I don't know the seller. https://bringatrailer.com/listing/fps-wheels-for-bmw/
Top