Search results

Try it again and let me know

Mine was a small block Ford.

Not sure other than the engine Pic. High bid was $2600 last week

This is kinda cool.. https://www.copart.com/lot/88464455/clean-title-1970-rover-3500-ca-sacramento This too... https://www.copart.com/lot/43900785/clean-title-1973-porsche-914-ca-sacramento

Maybe broken from a hasty retreat.

I've wondered that also. They're are many two-piece driveshaft assemblies out there and the ones I've seen in person are more robust. The one I put on the E3 must've been faulty or old "new old stock".

I bought the center bearing Rich replaced for about $30-40 and a few hours of work and it lasted about 300 miles before the rubber cracked and fell apart. The $250 bearing looks pretty good now.

It looked that way. The bottom third of the door was packed full. Didn't seem to cause additional rust but the truck has been in CA for the past 12+ years so that helps.

Working on parts taken off first then will move to the cab. Slow but learning as I go.

The Isetta is offended.

Where does the $85k number come from? How did you determine that value?

I hurt my wrist the other day soooooo.......

If it's hard to get off it's a good base and just needs to be sanded smooth. Consider it the primer coat so to speak.

My 69 2800 was a manual box with the bus steering wheel.

IP address is Hong Kong. Let's assume a language barrier before getting ahead of ourselves. @Nee loh , more personal info needed. Dan

I'd paint it the same as the exterior.

What paperwork do you have?

Says he's in Orange CA on other forums and IP address is consistent.

That's a '69 2800.

How have you found the time? Oh, nevermind. ;)