1973 E9 Carb Help Please

pickman

pickman

Well-Known Member
Site Donor $
Messages
427
Reaction score
152
Location
South Haven Michigan
I have two different connecting rods to my Carbs that make the operation of the linkage difficult. The attached photo is of the 1321125081 (#14)rod I have one of these and it works great I need another or a suggested replacement so I have a pair.

Can anyone please advise where I can get these?
 

Attachments

  • 13211250819.png
    13211250819.png
    18.2 KB · Views: 132
W & N sells the other one #14 is a complicated little connector with the ends being L & R hand thread The rod ends are not like anything that I have seen on other cars as they are a male end with a small thread The center piece is special to just this application You could make something using female rod ends with a rod made for the center I think that all the connectors like the other one available from W &N are the same thread both ends Someone might have a good used one

Thanks, Rick
 
You must log in or register to reply here.
Back
Top