74 3.0CS Cylinder head needed

buddha said:
I have an ‘82 1277378 head that came off my ‘74 3.0CS parts car. I’m building (one day) a M90 for my ‘70 2800CS, so I don’t need it. Start a conversation if interested.
Click to expand...
Hi Buddha, May I please have a couple pictures to check thickness max 128.6mm original is 129 mm thickness. Also would you need able to sell the upper timing cover as well to make sure it matches? I’m interested and keen to follow up on the same. Thanks
 
Buddha appears to have what you need- a later head with the fuel pump provision.

In regards to running an electrical pump on a carbureted car- without a shutoff device, that was outlawed for manufacturers in this country 50 years ago for obvious safety reasons. No electric fuel pump can run continuously unless the engine is cranking or running. I’m not a fan of unregulated electric pumps on carbureted cars.
 
Hi Budda, I’m interested in your 82 1277378 cylinder head. Please forward some pictures and hope to see the head thickness measurements of 128.6 mm minimum. Thank you
 
I’ll have it measured, cleaned and pressure tested. Will post pics if all is good. The dimples look good.
 
I’ve searched within a 50 mile radius and found no machine shops in my area. Apparently, it really is a dying trade. I’m out of options for continuing.
 
Don't let the minimum thickness requirement get in your way.
The thick gasket is available.

1Cylinder Head Gasket Asbestos-Free2,10MM(+0,3)
01Cylinder Head Gasket Asbestos-Free111129065649


Have Buddha put the head on the counter at FedEx.
Tell them to box and ship to you. (or me)
 
sfdon said:
Don't let the minimum thickness requirement get in your way.
The thick gasket is available.

1Cylinder Head Gasket Asbestos-Free2,10MM(+0,3)
01Cylinder Head Gasket Asbestos-Free111129065649


Have Buddha put the head on the counter at FedEx.
Tell them to box and ship to you. (or me)
Click to expand...
Thanks Don! I just replied to his message.
 
buddha said:
I’ve searched within a 50 mile radius and found no machine shops in my area. Apparently, it really is a dying trade. I’m out of options for continuing.
Click to expand...
Hi Budda, May I arrange to pay for part? I can zelle or PayPal. Please advise how you would like to handle payment. Kindly send me a couple pictures as well. I have a fed ex account that you can use for shipping if this is easier.
Thank you
 
You must log in or register to reply here.
Back
Top