Body panels & sheet metal- best fitment?

wab_jr

wab_jr

Active Member
Site Donor
Messages
47
Reaction score
49
Location
Jackson, MS
I’m creating the sheet metal list for my ‘72 csi. Is W&N my best source for sheet metal? Is their fit acceptable?
Thanks
Billy
61FFBCB3-D676-4E11-8945-286C85338B84.jpeg
 
wab_jr said:
Thanks for the link. Beginning to assess my sheet metal needs.
Click to expand...

Since there are multiple answers and sources, the search function will guide you to the most recent discussions on practically any question you might have. Always a good place to start.......
Sheet metal was also re-discussed only but a few months ago and often discussed at the current and ongoing restorations.

Keshav
 
Keshav said:
Since there are multiple answers and sources, the search function will guide you to the most recent discussions on practically any question you might have. Always a good place to start.......
Sheet metal was also re-discussed only but a few months ago and often discussed at the current and ongoing restorations.
Keshav
Click to expand...

What Keshav said. And if you need some particular piece, you can post a WTB (want to buy) inquiry in the Parts forum. Craigslist also has parts cars and pieces from time-to-time, like these: https://losangeles.craigslist.org/lgb/cto/d/santa-barbara-bmw-30-cs-e9/6904194768.html
 
We have established that W&N rear floor panels are the choice while Mike Pelly=Wolf Steel Restorations are the choice for front floor panels.
 
Markos said:
No, those are high for “by owner” sales.
Click to expand...

Especially where you can’t tell what’s under that paint. Markos knows, but I sense its pretty tight when high-end restoration folks are out picking the same parts we are, which I’ve seen a couple of times lately.
 
You must log in or register to reply here.
Back
Top