Malc
Well-Known Member
Had to be done...
Malc
Malc
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
DOB, Flipping Heck!
- Thread starter Malc
- Start date
Mike Pelly
Well-Known Member
floor pans
Malc-where did you get those floor pans?
Malc-where did you get those floor pans?
steve
Well-Known Member
All I can say is wow! I'm in awe.
Malc
Well-Known Member
Re: floor pans
Hi Mike
I got them from Jaymic in Cromer, Norfolk UK
They were ok but needed a lot of "twiddling" (read large hammer) to get them to fit to a point where I was happy
Remember to get the same "look" you can always take an angle grinder to a scrap/crashed more modern BMW. Oooh yes please!
Malc
Mike Pelly
Malc-where did you get those floor pans?
Hi Mike
I got them from Jaymic in Cromer, Norfolk UK
They were ok but needed a lot of "twiddling" (read large hammer) to get them to fit to a point where I was happy
Remember to get the same "look" you can always take an angle grinder to a scrap/crashed more modern BMW. Oooh yes please!
Malc