windnsea
Well-Known Member
I finally decided to put new hood support ends onto my hood support as the others were internally worn-out. Do you need to preload the two rods going through the tube so that it will support the hood in both the open and closed positions? I couldn't find anything about this in the factory shop manuals for E3's that I have.
I'm finally completing my 2800 Bavaria that was Alpina modified by the first owner through Mike Dietel. It now has a 3.9L fuel injected engine with a 265-5 close-ratio 5-speed and a 3.45 limited slip with the european 635csi oil cooler! A few flaws, but it has not been registered since 1992 and is going to be fun to get back on the road!
Gary
I'm finally completing my 2800 Bavaria that was Alpina modified by the first owner through Mike Dietel. It now has a 3.9L fuel injected engine with a 265-5 close-ratio 5-speed and a 3.45 limited slip with the european 635csi oil cooler! A few flaws, but it has not been registered since 1992 and is going to be fun to get back on the road!
Gary