e3 parts fits this parts in e9 cs 3.0

D

dennis

New Member
Messages
4
Reaction score
0
hello
i want to ask something
dothe understel where the motor is on the e3 fit pas in een e9 cs

what about de vering and sckokkenbreker leg do this fits in the e9
if it comes from a e3
i ask this because iam gone put a motor from a e3 in a e9 a nd i have the hole car
 
schokken brekers onderstel past dit van een e9 in een e3

the understel en veerpoten are these tthe same
 
Mechanically, the e3 and e9 are very, very similar. The engine, transmission, differential, front subframe, steering parts, brakes, are all the same. Rear subframe is not the same.
 
subframe iseu

everbody thank you -/* for the information iam gone try to tel you why is
ask all of this
iwant to put a engine of a e3 in a e9
is it so that the subframe of the e3 is soepel
en the subframe of the e9 is more stug because thids is more sporttief
that when i put the subfame and vering and schocken brekerof the e3 in the e9 the car gone drive more soepel than before because the e3 is more made to drive soepel en the e9 more to ride sportief
 
Dennis,
You may not get what you expect.

The front suspension and subframe of the e3 and e9 are almost identical from the factory -- same strut tubes, dampers, bushings, etc., etc. The only difference might be the rate of the front springs, as there were several options for both e3 and e9.

If the two cars you are swapping parts on have not been modified, you may notice no change in driving feel.

If you want the e9 to be more supple, you can change the springs and dampers without the difficulty of swapping the entire subframe and engine.

Cheers,
 
thank you than i now now enaf

if get moee problems you gone hear it from me
 
You must log in or register to reply here.
Back
Top