Engine bay wires ID

Stevehose

Stevehose

Well-Known Member
Site Donor $$
Messages
13,399
Reaction score
6,202
Location
Sarasota, FL
I am redoing my engine wiring harnesses, these 4 wires come out into the engine bay through a hole in the firewall to the right of the steering column. Are these the Zenith choke wires and speed sensor wires? They are green/white, violet/black, brown, and blue/black. Can't find anything definitive on the wiring diagram. I am thinking I don't need these given that I have neither emissions crap or Zeniths any more. I had 2 of them tied off before so I want to confirm the other 2 before hiding these.

IMG_4137.jpg


IMG_4139.jpg
 
No direct answer but everyone is offline today. :D Lot’s of historical chatter on the green/white wires.

Check this recent post out:

2800cs zenith wiring

Hi everyone, as many of you know, I have recently purchased a second e9 (1972 2800cs). The car idles at 2100 rpm, and after reading through many older threads and posts here on the forum I have come to the conclusion that the chokes on the carburetors are not receiving power. The carbs each have...
e9coupe.com e9coupe.com
 
Cut the zip tie and stretch out the wires

USA carb cars had a smog device at the middle of the firewall
 
I pulled these unused wires (I agree they’re likely for the carbs) back through the firewall to their source-I was going to zip tie them out of the way under the dash when I noticed that they unplug conveniently from under the steering column so out they came and into the “I’ll keep them in case I need them again box” which never happens.

IMG_4470.jpeg
 
You must log in or register to reply here.
Back
Top