dascoupeguy
Well-Known Member
I acquired a set of 2800cs headlight grilles a while back for my project... These were in very good condition. I recently went to install them on my 3.0cs and was shocked to find that mounting holes did not line up. These were the only holes (on the top) and were off by an inch or two. There were no evidence of extra holes being drilled, nor was I going to drill new holes.
My question for all y'all is, were there distinct differences between the 2800 and 3.0?
If I looked correctly at Penske, they give the same part no for both.
I will be offering these soon after I get addl info on these. Thanks DCG
My question for all y'all is, were there distinct differences between the 2800 and 3.0?
If I looked correctly at Penske, they give the same part no for both.
I will be offering these soon after I get addl info on these. Thanks DCG