Fuel injector spacing

B

BonitaCS

Well-Known Member
Messages
169
Reaction score
1
Location
Bonita CA
Does anyone know off the top of their head the fuel injector spacing (center to center)? I can measure each one and take an average, I don’t think they will differ by much but, if someone knows the number it would be nice to have.

Scott
 
The spacing is indeed 100mm centre to centre, but slightly offset towards the rear of the engine
Malc


dfd5e4f60f87c279cb804311f58c97c3.jpg
 
Thanks Bert-Ola and Malc. That is what I measuerd last night as well. It lookls like the injectors come out at a slight angle aft as well.

Scott
 
Yes. Did most of the machining today and did a fit checked this evening. I need to decide how I want to tie the rail down and I have a few things left to clean up then its done; anodize? I bought two feet of 6061-T6 extruded rail from RMR ($10.00/ft) but they screwed up and sent me four feet; kind of like ordering tan arm rest brackets and getting two sets :p . I was thinking about pulling off the manifolds and seeing if I could clean up the injector port so the Motronic injectors fit better. The injectors are at a compound angle so would need to build a fixture to hold the manifold; well see how ambitious I am over Christmas...

Scott
 
You must log in or register to reply here.
Back
Top