Having enthusiastically undertaken an involved project recently, figured I should refresh my welding skills and asked for advice from some welding pros.
Was surprised to hear about MIG Brazing. Remember torch brazing from old days, but to hear "manufacturer recommended" and "specified" felt compelled to find out some more.
Low distortion, low heat, less likely to ooze rust out of pores and other good thoughts.
A video discussing process; I'm sure there's better:
There's an official I-car class (feel free to skip this one)
Has anyone had any experience with or exposure to this method? Intended use is for typical CS panel repair - patching - rust holes.
Was surprised to hear about MIG Brazing. Remember torch brazing from old days, but to hear "manufacturer recommended" and "specified" felt compelled to find out some more.
Low distortion, low heat, less likely to ooze rust out of pores and other good thoughts.
A video discussing process; I'm sure there's better:
There's an official I-car class (feel free to skip this one)
Has anyone had any experience with or exposure to this method? Intended use is for typical CS panel repair - patching - rust holes.