Rear window motor needed

[Gary Waggoner]

For my 1970. Gear is stripped on motor.

 

[Koopman]

Hi Gary. Do you want to replace it with an E28 motor for faster up and down. I will have a few in about 10 days.
Koopman

 

[Gary Waggoner]

My rear windows worked awesome. I cleaned and greased everything and added relays to run the motor. I think I will look for original or replacement gear.

 

[Stevehose]

So you need the gearbox not the motor?

 

[Gary Waggoner]

Yes, if that is an option. My motor is fine. Didnt think people would separate.

 

[rsporsche]

previously there was a discussion about 3d printing the gear. where is this discussion now? this is what you need. its not that difficult to take the gearbox apart.

 

[rsporsche]

here is the link to the previous discussion
https://www.e9coupe.com/forum/threads/window-transmission-gears-3d-printing.24773/page-3#post-184496

 

[Gary Waggoner]

I PM'd him yesterday already. No word back yet.

 

[3.0seeker]

Hi Gary. Do you want to replace it with an E28 motor for faster up and down. I will have a few in about 10 days.
Koopman

I would like new E28 motors if available!

Terry

 

[Drew Gregg]

Hi Gary. Do you want to replace it with an E28 motor for faster up and down. I will have a few in about 10 days.
Koopman

I'm trolling through all of the parts sales. The car I just bought does not have working back windows on either side. Should I buy the motors or pull the panels/switches and see if there's 12 V going to them first?

 

[BBOY]

Hi Gary or any member, if you're still looking for OEM rear motor I have a few. Please let me know.

 

[Stevehose]

Definitely check for voltage first, the motors rarely go bad.

I'm trolling through all of the parts sales. The car I just bought does not have working back windows on either side. Should I buy the motors or pull the panels/switches and see if there's 12 V going to them first?

 

[deQuincey]

I'm trolling through all of the parts sales. The car I just bought does not have working back windows on either side. Should I buy the motors or pull the panels/switches and see if there's 12 V going to them first?

doing a fine search you might find this interesting to try first.

https://www.e9coupe.com/forum/threa...s-and-trim-panels-regrease-and-renewal.11320/

 

[Tony.dreamer]

previously there was a discussion about 3d printing the gear. where is this discussion now? this is what you need. its not that difficult to take the gearbox apart.

I used two 3D printed gears memeber Travis designed and printed and sold me at very reasonable price. They worked well! Another member recently contacted me looking to buy some gears but Travis has not responded to our requests ....