I am planning to install an OEM fog light switch in a blank position on the lower dash / kick panel.
I know the back of the panel is flocked sheet metal and I have a variety of hole saws and am sure one will come close to the right size, but I want to be careful not to tear the padding on the outside of the panel. Any recommendations on how to handle?
My guess is to use a razor blade to score the padded section to expose the metal and drill through from the front. Recommendations are appreciated!
I know the back of the panel is flocked sheet metal and I have a variety of hole saws and am sure one will come close to the right size, but I want to be careful not to tear the padding on the outside of the panel. Any recommendations on how to handle?
My guess is to use a razor blade to score the padded section to expose the metal and drill through from the front. Recommendations are appreciated!