Rocker molding.

[HemptasticG]

Good morning everyone, Im getting close to completing the body for paint. but am curious about the rocker molding, in a previous conversation I identified that they are fastened on, does anyone know the correct fastener position? if so please help with pictures.
Thank you.

 

[eriknetherlands]

Are you talking about the steel panel between the wheels, below the door, or the rubber/shiny strip on top of it?

The steel panel (often called "Decorative sill cover trim moulding", or any combination thereof) is attached with cross headed screws. A few on the bottom, close to the edge, running the length of the sill. also 2 screws inside both wheel arches.
The rubber/shiny strip is attached with white plastic clips to the steel panel. It works best to attach it first to the decorative sill, and then screw the whole lot on the car.

there are a few threads on the forum, they'll help you get started.
here's a link to how I fixed the rubber pieces to the steel part.

Fixing that little rust spot...

continued from previous. (passenger floor welding) 212533, checking and correcting flushness before and after tack welding 215536, butt welding the new panel to the rear floor (also new, installed earlier) 221131, my trick to get the epoxy as best as possible into the weld seam. I modified a...

e9coupe.com