Sold: Complete Rear bumper & bits - $1K

Markos

Well-Known Member
Site Donor
Messages
13,369
Reaction score
7,517
Location
Seattle, WA
Hi Folks,

Time for me to make some trade offs. This is no flip, I should really be keeping this bumper. However, if is the easiest way to neutrally address my latest impulsivity. :D

I am selling this bumper as a complete setup. I searched around and it looks like core bumpers are going for $1,000 each end. I know I have helped a few folks source some domestically at that price point. We know that folks want over $100 for the little chrome center piece, and $200 - $300 for underriders. Based on what I found, my price for all of the above seems reasonable. Nobody is going to open a box with a $1,000 driver-grade bumper and be super thrilled, but these are the times that we live in. :D

Lots of pics. This is the combination of the best of my two rear bumpers. The left side is mounted to my project car. It was an OEM replacement in the ‘80’s due to a rear-end collision. I still have the orange sticker on my tail panel. This piece has some surface swirls near the plate light, but is in overall very good shape.

The passenger side is from the CSI donor, guaranteeing that you are buying to euro halves. This piece is a bit more dull. There is a dime sized “surface crinkle” below the rear reflector area on the top of the bumper. The under side on the fender area is more dull than elsewhere, but obviously less notifies me. There is some swirling near the plate light, and it is nearly completely covered (and likely caused) by the light.

Underriders are in very good condition.They are dirty on the inside but not rusty, and are structurally sound. The chrome is in good usable shape. There is a small stain on the driver’s inboard section of the underrider, about the diameter of a pencil.

Rubber included, and I have three to chose from, picking the best. I also have the clips from both bumpers to cherry pic. The current rubber on the red car is slightly wavy from me pulling on it to clean the edge.

I will clean these well before shipping, but don’t expect any “my show car won’t need chrome” miracles. Use the bumper as-is for your driver, or rechrome without metal prep. I will be sure to
scrub the innards as well.

PM me for details. I’m up for split shipping or an agreeable discounted flat rate. These bumpers aren’t too heavy or big once disassembled so I think I can get these to the lower 48 at a very reasonable rate.

8BD53B30-80A7-4EA2-BBFB-74C1CBA9DC74.jpeg



AFCD29A2-B149-4470-AA15-280499F68A63.jpeg


B5C6B7F8-3DD0-4BF0-8156-05A190C5B8D9.jpeg


1BB59BF4-C162-4965-9ED1-8DFCCD6725AC.jpeg


55A0865C-AA3A-4302-A605-5A340F6193ED.jpeg


AEB54787-167A-43A8-8326-6D3D69B16A2B.jpeg
 
Last edited:
Ignore the center section. Nicer on the mounted bumper.

1A642B5E-518B-4056-81AB-51DE3D321548.jpeg


1A642B5E-518B-4056-81AB-51DE3D321548.jpeg


F8C268DF-2236-4458-A433-E747DC06946B.jpeg


A0A12EE0-E696-405D-B76D-95B33DD59C4F.jpeg


2973A5BD-7EA5-4CD5-B100-283DACDF61A3.jpeg


24B2B232-5494-4B65-899F-D82499654C70.jpeg
 
Last edited:
Unable to send PM, puts an x in front of you user name. I’ll take the center piece (finisher) and the underriders. Please send PM and maybe it’ll kick start mine. Thanks
 
Hey Mark,
It wasn't clear to me in your post that you are interested in selling of bits and pieces. independently but if so (as started by @Bimmer 3.0 CS ), I would like the left half please. I bet it can go in the box with some other parts from your garage. ;)
Thank you,
Stephen
 
Now Markos can buy all those Beanie Babies he's been after!

You remember!

The matching vintage beanie babies that I purchased are black with dark grey stripes. They are named “Scheel”.
 
damn… i did throw away perfect front & rear bumper in 2014 building the rally car ... times can change. :rolleyes: :D

bmw 2800 cs 007.JPG
bmw 2800 cs 010.JPG
 
On another note-I noticed a little wavy-ness in the rubber guard- that is usually the result of a squashed channel attached to the chrome and is easily fixed by putting new channels on the bumper- you all probably know that but I felt I had to add something to this conversation.
 
Nice to see a asking price on parts being sold !!!
Bumpers of this quality have sold for over 1k here in the UK
 
Back
Top