WTB glove box shaft and hinge levers

S

stphers

Well-Known Member
Messages
1,228
Reaction score
630
Location
Port Moody, BC ( near Vancouver, BC )
I am looking for the shaft that has the hinge brackets with the 2 pins that hold it to the glove box sides

Thanks, Rick Found the shaft that I needed Still looking for the seat release levers

Thanks, Rick
 
Last edited:
Still looking!! Also need these seat back release levers These attach to the rod that runs thru the bottom of the seat back and to the actual release catches These have the circlip groove edge broken off and the clips don't stay in Will need 4 of these can I be this lucky?

Thanks, Rick
 

Attachments

  • Seat bracket 1.jpg
    Seat bracket 1.jpg
    144.5 KB · Views: 63
  • Seat bracket 2.jpg
    Seat bracket 2.jpg
    139.7 KB · Views: 59
No it is all E9 stuff but I wonder if the bracket for the glove box is the same? # 17 for glove box piece and
unfortunately the seat pieces do not show up in the parts book. I will try and get a picture tonite of how they sit in relation to the rest of the seat

Thanks, Rick


Glove box
 
Hi Your reproduction is very nice but in reality by the time I pay the exchange, duty, shipping and the actual cost of the part, it will be close to 500 Canadian I just can't justify that much for a glove box hanger Push comes to shove, I can make one and either powder coat or plate it myself Thanks Rick

Still looking for those seat back release levers those will be a little harder to make

Thanks, Rick
 
Thanks, I appreciate that offer but I think I will see what I can find used In my second post, there pictures of part of the seat back release mechanism, these are attached to the long rod that runs thru the seat from side to side at the lower section of the seat back These attach to another lever that the cable actuates from the side lever so the seatback unlocks and can be moved forward

Thanks, Rick
 
You must log in or register to reply here.
Back
Top