Latest activity
-
ScottAndrews replied to the thread Rear Wheel hub removal: Help Needed.Looks great!! I can see the amount of work all that was!! I recommend you wire brush and paint the hub centers.. -
ScottAndrews replied to the thread Some help getting engine started.That is SOOO weird, because with the engine running the other side of the ballast resistor (the non-coil side) is at 12 volts, energized...
-
autokunst replied to the thread Copart BMW finds....It does have three pedals. The clutch pedal is barely visible in one of the photos. :) -
jmackro replied to the thread Copart BMW finds....And although Copart says it's an automatic, the gearshift lever and dashboard sure make it look like a three-pedal car. -
Rrblongboarder replied to the thread Copart BMW finds....That's actually a E3 / 3.0s in pretty good condition.
-
e9Leveque replied to the thread CSI auction by DuPont Registry.What did it sell for in the end? -
Eh….Grp 1 so yeah not anything like a full blown grp4/5 factory car…Carbon fiber is just tape on one bar. Has FIA pass so yes REAL race... -
autokunst replied to the thread Copart BMW finds....I was pretty uninspired to look at it until it opened and I saw the "i" should have been an "e". Much better!
-
dang replied to the thread Copart BMW finds....Looks pretty solid. Bid to $1900 last week. https://www.copart.com/lot/48713776/clean-title-1973-bmw-i3-ca-martinez -
rsporsche replied to the thread brake discs (front / rear).hmmm ... i hadn't heard that one ... i bought them from @Bert Poliakoff a while back ... i have them all boxed up and ready to go to... -
rsporsche replied to the thread brake discs (front / rear).in looking at the tariff schedule <revision 8> 2026 section 8708.30.50 - brake parts for cars = rates of duty (as long as they aren't...
-
Paulaner replied to the thread Rear Wheel hub removal: Help Needed.Nice, wish I had known about these earlier. Will go into the backlog for now. Ain't disassembling the rear end again any time soon -
Paulaner replied to the thread Rear Wheel hub removal: Help Needed.Correct, that's right. The new covers have a bevel to them and the dual bolt washers wouldn't fit. I used what I could find at the local...
-
Been making good progress, rear end is nearly back together. Was hoping to be onto the transmission and clutch by now, but you all know... -
Been making good progress, rear end is nearly back together. Was hoping to be onto the transmission and clutch by now, but you all know...
