Visor brackets are done at CK

sfdon

sfdon

Well-Known Member
Site Donor $
Site Donor $$
Messages
9,164
Reaction score
5,836
Location
sfbay area
7ED2F997-E1BA-4EF7-8866-36E476AEDDD2.jpeg
major pita to get these done..

Contact Andrew at CK for pricing.
 
I plan to grab a set of these; I cracked one of mine pulling the other end of the visor from a newish holder.
 
zinz said:
What we need are the visor clips... :(
Click to expand...

Speak for yourself. I'm missing one of these completely and I'll buy two so that they match and avoid the breakage of the driver's side which will happen .002 seconds after they sell out. :-\
 
It is not difficult to take the original pivots apart and have the arms chromed. Then take the white (now yellowed) base, clean it then paint it with sem or equivalent paint. I did this with pretty good results.

IMG_8197.JPG
 
Fwiw...throwing this out there......I recently bought a set of visors with clips for my air cooled VW Type 3. The pivots with the rods look just like these. They came with clips and were 20 or 30 bucks for a pair...
The vdub visor is about 16 inches. Haven’t had a chance to do a side by side.
 
I was thinking of these white ones. Only talking about the pivot with the arm. If the pivot mount holes are the same distance apart wouldn’t the vw ones work? I think mine came with the clip for the other end. Those look different but might work in a pinch.

https://www.cip1.ca/ProductDetails.asp?ProductCode=C13-4423
I will measure the Center to Center holes later and post a pic...
EE77E997-B5D4-4F06-89F5-4F28D4B4DA36.png
 
You must log in or register to reply here.
Back
Top