Door opener connection rod
- Thread starter tronch
- Start date
Interesting, mine (1972) is different than shown, it is bent around the connection points rather than straight and pushed into retainers. It is possible that this was done when the door was opened for metal repair in the past.
My measurements are about 57 cm point to point, but I have a loop, at least on the door post connector. the thickness is just under 4mm.
My measurements are about 57 cm point to point, but I have a loop, at least on the door post connector. the thickness is just under 4mm.
Pic is not correct, they have a loop at each end with a plastic grommet.
Hi Chris. Please let me know the length of the rod you need. I may have one.
Not for sale, but see dimensions in the pictures. It is from a 2800CS from 1970. 3.7mm thick, 55.5mm from end to end, measured with the bow included.
Attachments
I have a rod that is 20 inches long but it dose not have the adjusting connected that is in the center of the long rod.
That is just a triangular piece of rubber where it passes the window frame.
I guess the 3.0Si has a longer rod.
Thanks for the correction.
Thanks for the correction.
Harry, 20” is 55cm so your rod might work. The Si would have a shorter rod I think as the door is shorter as well.