I am replacing my clutch for 71 2800CS does anyone have a source for a new flywheel?
Source for Flywheel
- Thread starter Wobdog
- Start date
Resurface yours?
Ch
Chris the idea was to reduce down time. Ideally would be great if some type of exchange program.
Mike--Here's the name of the alum. flywheel on my Korman engine, bought by the previous owner in 2006. The website -www.JBRacing.com--, says they make a flywheel for the 2002,but the model # 520-090-240 might be still available.
The TDC and timing mark are NOT on the edge. We just timed the 123 dizzy with the marks on the harmonic balancer, w/o a timing light.
Attachments
I'd buy a good used one and have it surfaced. Then just swap out the flywheels and have your old one resurfaced to sell.
When I resurfaced mine I dropped it off in the morning at local Seattle shop and picked it up 4 hours later. Not much down time there!
I resurfaced mine in about an hour. Drove to Don's with my old one, swapped, and drove home with a pristine one... 
Since when have you had a pet?
That's deep man..I thought we were the pets and Don was our shepherd
I finally captured the cat that’s been sneaking into the shop and sleeping in all the cars….
Trying to do the right thing I took the cat in the trap down to the local vet to get him neutered.
The vet explained the cat had already been neutered and belonged to a neighbor.
It wasn’t a good morning…..
Should have taken it for a drive to Oakland..