Cheap Parts car in Virginia
- Thread starter OCCoupe
- Start date
pamp
Well-Known Member
Cool,
A 1976 would be awesome. Got to be rare.
Must be a '74
A 1976 would be awesome. Got to be rare.
Must be a '74
psychrunner
Well-Known Member
I may check it out
I live about 5 miles from this address. May swing by and check it out tomorrow. Anybody need any specific info?
psychrunner
I live about 5 miles from this address. May swing by and check it out tomorrow. Anybody need any specific info?
psychrunner
I would like to know if is a manual trans.
I looked at badly rusted 72 last week but it was an Automatic.
John M
I looked at badly rusted 72 last week but it was an Automatic.
John M
psychrunner
Well-Known Member
okay
Okay, I may be able to get by tomorrow. Called the owner this P.M. Sounds like its a small car dealer/lot. I may not be able to get pics. Sorry.
psyran
Okay, I may be able to get by tomorrow. Called the owner this P.M. Sounds like its a small car dealer/lot. I may not be able to get pics. Sorry.
psyran
psychrunner
Well-Known Member
Bad shape
Looked at the car yesterday. Rust all over, no engine in the car nor is it available. Don't see it worth it, even for parts. Vinyl (blue) not bad however. There was one part I am interested in in. The large round knob that moves the seat back up and down. Couldn't figure out how to get it off (the owner said I could swap my chipped one for the on on the car), nor how to get his off. Any body know this procedure? BTW, car is automatic. Much of the rust is through metal on panels. Not sure what can be done with it.
Randy
Looked at the car yesterday. Rust all over, no engine in the car nor is it available. Don't see it worth it, even for parts. Vinyl (blue) not bad however. There was one part I am interested in in. The large round knob that moves the seat back up and down. Couldn't figure out how to get it off (the owner said I could swap my chipped one for the on on the car), nor how to get his off. Any body know this procedure? BTW, car is automatic. Much of the rust is through metal on panels. Not sure what can be done with it.
Randy