how do you remove the wood dash runners
to redo
to redo
dash runners
- Thread starter aearch
- Start date
runners?
Alan,
If you mean the wooden "shark fins" that separate the vinyl tray into sections, they have a tenon machined on the underside, that fit in, and are glued to the pine/spruce plywood panel...(The "fins" are apprx 4" x 11/32" overall...the tenon is apprx 2 13/16" x 3/16")..so if your glue isn't loose (you may be able to left and right tap to loosen..), then the only alternative may be to carefully measure and router out the bottom of the plywood panel to release the "fins", tapping up from below...Or maybe you could slide a thin metal putty knife under the shoulder and pry them up, but I would worry about breaking
the "fins"...Hope this is clear.
Dave V. in NC
Alan,
If you mean the wooden "shark fins" that separate the vinyl tray into sections, they have a tenon machined on the underside, that fit in, and are glued to the pine/spruce plywood panel...(The "fins" are apprx 4" x 11/32" overall...the tenon is apprx 2 13/16" x 3/16")..so if your glue isn't loose (you may be able to left and right tap to loosen..), then the only alternative may be to carefully measure and router out the bottom of the plywood panel to release the "fins", tapping up from below...Or maybe you could slide a thin metal putty knife under the shoulder and pry them up, but I would worry about breaking
the "fins"...Hope this is clear.
Dave V. in NC
Remove
Do you know deep i need to route to expose the
plates
Do you know deep i need to route to expose the
plates
routing
PM sent
PM sent