Engine bay

aearch

aearch

Well-Known Member
Site Donor $
Messages
4,122
Reaction score
592
Location
pleasant hill , ca
Could someone post pics of the engine bay
so i can see the fender top pads in place so i know where they go
and maybe electrical layout
thanks
 
Passenger side:

IMG_2099.JPG

IMG_2100.JPG

IMG_2101.JPG


Driver side:

IMG_2102.JPG

IMG_2103.JPG

IMG_2104.JPG
 
I can send you some photos also

a couple questions,
Where did you get the sound damping material?
The German guy, Christoph, has ti but the textures don't look quite like the one in my car
What are you doing for decals? I see several people sell them, I wonder which are best?
 
the way I understand it, the bulk material is smooth, someone sent me the part number, it is that same as used on floor pans

The German guy has material cut to size and with patterns (texture) on of which is a hexagonal, but it doesn't look like a match to me
 
Hi Chris
Are you saying the current BMW bulk material has an emboss and not smooth? Would you happen to have the part number for that?
What is the emboss like? My car, it has a very fine diamond pattern and a light hexagonal pattern over that
 
Be patient and practice using the material before you attach it to the car. You can cut it with a good utility knife and good utility scissors. It'll get tacky really quickly with direct heat. I suggest cutting your patterns a little big then doing a final trim prior to installing them in the car.
 
Last edited:
stickers

the stickers i found on ebay
which are original
i have an extra set for the csi
also i had someone there make me a new
serial number tag
thanks occoupe
 
decals

I see a couple people selling decals on Ebay, but reproductions, I wonder which set is better?
 
Hex pads

Here is a set I made. This is using the correct BMW material.

I can make a set for anyone who is interested.




 
Sound damping material

[FONT=&quot]Sound damping material - [/FONT]I am interested
I saw your email in a different post so I am trying that
Mark
 
rsporsche said:
Mike,

how much would you like for a set?
scott
Click to expand...

Scott,
I am cutting these out by hand and not with a dye press. I would have to say $250.00 for a set. I would also include a little extra material so that you can practice installing the pieces. The two pieces that go next to the heater motor are the hardest to instal and take a lot of patience.
 
You must log in or register to reply here.
Back
Top