Front indicator Part needed

[Rek]

In preparing the indicators/turn signals for re-chroming, I broke one of the bulb holders taking it out. One came out fine, pictures attached, but the other did not fare so well.

Does anyone have any ideas for a replacement or am I the first with this predicament, or clumsy enough to make this mistake?

 

[aearch]

jb weld it back in

 

[Rek]

Its not that its come out - it that one of the discs broke when I was taking it out. This is the good one for reference.

I am trying the epoxy route on the disc but it might not be strong enough.

 

[Belgiumbarry]

yes, glue them back in … i did it. Just be careful with glue that the spring keeps working !

 

[dp]

if you glue it in, wouldn't you be disqualifying yourself from the "Gee my car is gonna be worth 80K GBP someday" crowd?

 

[Belgiumbarry]

don't worry dp , glued in is better than the oem press fit !

 

[Rek]

This is my problem ie the disk attached to the moving contact broke whilst I was removing it. Not the refixing of the assembly - but the replacement of it, or repair. It was in four pieces but is now in two. I would prefer a complete new assembly.

 

[Rek]

Used Araldite (JB Weld equiv here)