FS: Complete set of Weber 32-36 with linkage and intake manifolds for M30

[Bmachine]

These came on my car when I bought it. Worked great. Moving on to a Motronic motor so I do not need these anymore.

Cleaned up and ready to install. $300 plus shipping.

Bo.
Note: I will include the existing gaskets for reference but obviously you would need a fresh set to install.

 

[pat cooks]

does the standard air cleaner fit on top of these,I assume are they jetted for a 3.0 what would the shipping to San Jose CA be? Pat

 

[bengal taiga]

Ordinarily,adapter plates (pictured) allow the stock air filter to fit the Weber carburetors. That does not preclude some other workable filter housing modifications by a creative metal worker.

 

[Bmachine]

does the standard air cleaner fit on top of these,I assume are they jetted for a 3.0 what would the shipping to San Jose CA be? Pat

Hi Pat.
Yes the standard air filter fits perfect on these. That’s is how it was set up on my car. I am selling the original air filter separately. I will post pics later today.
I do not know which jets are installed but since they were on my M30 I assume they they are jetted for it.
Shipping for the whole thing to San Jose would be maximum $30.
Bo.

 

[Bmachine]

And here are the adapters that come with it. I didn’t realize I had left them on the air filter housing:

 

[pat cooks]

Ok, thanks, can I put my name on them, bit busy today to work out details, a lot of cooking going on here, and somehow my house is full of relatives, Pat

 

[Bmachine]

You got it Pat. No hurry. I’ll PM you.

 

[pat cooks]

ok, thanks, Pat

 

[pat cooks]

does anyone know if the manifolds are different to stock? might save some international shipping if they are no different,

 

[dbower]

I think those adapter plates need a rubber ring gasket on each carb where they meet the air cleaner housing. Found mine at Lowe's.

Don

 

[Belgiumbarry]

There are indeed rubber O rings between the adaptor plates and filter housing.
The manifolds are the OEM ones
What i see different on my setup are the thermal insulation blocks , they have 1 "oval" opening , not 2 holes as the carb and manifold.... what we see here in the pics.
When i look at Wallothnesch , the gaskets also have no bridge between the butterflies . Ofcourse you need 2 / carb.

Don't know what would be the best ???