G265 swap shifter rod

Thomas76

Thomas76

Well-Known Member
Site Donor $
Messages
1,320
Reaction score
772
Location
Michigan, USA
Just received a new shifter rod for my conversion and noticed one end is significantly wider than the other, much wider than the shifter.
I couldn't find anything in our support files addressing this so I thought I'd drop a question to document it for others.
Is it possible this is a flawed part?
PXL_20250122_235327413.jpg
PXL_20250122_235418562.jpg
 
That selector rod is for the later M30s with a wider transmission knuckle. You'd have to use washers to space it out or get the proper one. If you'd like to upgrade to a DSSR with bronze bushings on both ends, please check out our linkage systems at:
www.2002sonly.com

The Ultimate Shift Linkage System for M30 | 2002s Only

Does your rod flop all over the place? Do you have a hard time getting it in the slot? Then our Ultimate Shift Linkage System is just the answer! Replace all the worn-out shifting components from the end of the shifter to the input rod on the transmission. And, get a DSSR to boot! We have...
www.2002sonly.com www.2002sonly.com

Hal
 
The short end goes to shifter, the longer to new style "wide" coupler on the gearbox, which takes longer to wear out before you need linkage kit anyway.
1737641462315.png
 
You must log in or register to reply here.
Back
Top