My ignition switch was only working in the start position when I pressed the key firmly into the lock cylinder. Based on previous threads I bought and installed a new ignition switch from W&N. Now the key doesn’t seem to rotate far enough into the spring loaded start position to start the car. I removed the switch from the key cylinder and the car starts when turning the switch directly with the key. The first time I installed the new switch I may have inadvertently left the the key in column unlocked position. Things didn’t mesh right with the cylinder because key wouldn’t turn into the start spring loaded range at all. After reinstalling with everything in lock position the key functions correctly except apparently not rotating quite far enough to start. Did I mess up the cylinder the first time I installed the switch? If so how do I fix it?