need new badges front and rear

[steve in reno]

I have original front and rear chrome bases.

The front is a flat base for use with a raised emblem badge, that I have found to be NLA.
Would the 747 number badge work in the base? It is 82mm. It is not raised, oh well. Size fits!

I also have a chrome rear base, scalloped for rear trunk. Can the same 747 be used for this base. Also 82mm.
Are the post spacing and post diameter usable?
I don't see any OEM info on spacer? Available, or make one

I already have new one piece badges for front and rear. The front one is raised emblem and a cast aluminum. The rear is pvc.
While they look good I have original bases that I would prefer to use.

Any good vendors with good badges and prices?

I know this horse has been beaten here before, and I did do a search first. But not the info I wanted.

I initially posted this on the projects page but no responses and never showed up on NEW posts, so try again

 

[Wladek]

Here you have raised letter 82,5mm front/rear badge: https://www.wallothnesch.com/en/badge-for-bonnet-and-boot-old-style.html
747 will not work with your separate bases, because it is single part badge integrated with base.

 

[steve in reno]

thanks.
Didn't see that 747 was 1 piece.

 

[nyccsi]

https://www.ebay.com/itm/173340715483?ViewItem=&vxp=mtr&item=173340715483
Lest than 2 bucks

 

[steve in reno]

Thanks but I already have a pvc badge.

I haven't seen the base gasket for sale or know of the pn#. None shown on OEM
gasket necessary? or make your own?

 

[mulberryworks]

Thanks but I already have a pvc badge.

I haven't seen the base gasket for sale or know of the pn#. None shown on OEM
gasket necessary? or make your own?

Already under discussion. Not sure what the latest progress is.

https://e9coupe.com/forum/threads/trunk-roundel-gasket.26741/