On the passenger side there is a plastic strip. On the the drivers side there is a small gap.
Is this the part?
Part # 51715776180
Does not look right.
Hi Gordon, there should be a flexible seal on the outside of both fender liners. I'm not sure if they are still available. If there is a gap then there is an entry point for water and other muck to enter so it should be cleaned, treated and sealed. There may be a small drain dimple at the bottom- not sure.
Peter;
Thanks. I will check out the area prior to the seal re-install.
The passenger side is nicely sealed. The driver side looks like it came out at some point. Can probably find a reasonable replacement for the BMW part.
Would like to see if I can locate the correct seal piece first.
Anybody have the part number or source? Because the part in real OWM looks like it is not a seal for the front surface per the picture.\
I measured the side that is in place. 8.5".
one side is all I need. But, it may still be available.
I think those pictures were taken at the optimal angle and location. Thanks
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.