Did 2 sets of these rear CS trailing arms sandblasted and powder coated. Zinc plated the rear axle parts. I have the 2 tiny spacers that go in between the cone spacers and bearings as well. Inner hub area needs to be wire wheeled before bearings install. Also, I don't have backing plates. this "tostada" looking one is free to buyer. Plated bearings and seals are only for display, definitely require new bearings inner and outer plus seals. Also the large nut on the axle shaft was used to preserve the threads for plating. One good one included and one new one, smaller profile, required. $1500 obo plus shipping or free local pickup in SoCal. An example of my completed ones is shown as well.
