I am just about to replace the rear springs, diff mount bush, rear damper upper mounts, and dampers (new Bilsteins). The shocks were very poor and one upper damper bush had failed, so I am hopeful that this will improve things no end. Any advice on the sequence or method?
What I have learnt so far is:
Damper upper mounts, remove metal bugs from the rubber, install rubber and then metal bush (tube). Do I need to jack this I. Bush in this a threaded bar and piece of pipe or can it be put in another way?
What I have learnt so far is:
Damper upper mounts, remove metal bugs from the rubber, install rubber and then metal bush (tube). Do I need to jack this I. Bush in this a threaded bar and piece of pipe or can it be put in another way?