Stub axle to drive flange torque setting?

Discussion in 'E9 General Discussion' started by VILLEocity, Feb 26, 2019.

  1. VILLEocity

    VILLEocity New Member

    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Darien, Connecticut
    The manuals I have say to tighten the flanged stub axle nut to torque spec but I can not find any listing for that spec in the tables. I am referring to the nut to the right in the cross section below. 41601004.jpg

    What should it be? Thanks!!
     
  2. VILLEocity

    VILLEocity New Member

    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Darien, Connecticut
    Anyone?

    Bump
     
  3. HB Chris

    HB Chris Well-Known Member Site Donor $

    View My Showcase
    Messages:
    10,706
    Likes Received:
    1,256
    Trophy Points:
    113
    Location:
    Huntington Beach, CA
    289-325 ft. lbs?

    A14B2EC9-6D9F-4AC7-96E3-F41D84A1A62A.jpeg
     
  4. VILLEocity

    VILLEocity New Member

    Messages:
    9
    Likes Received:
    0
    Trophy Points:
    1
    Location:
    Darien, Connecticut
    That should hold it! The terminology for the parts is different than the manual I was using but I guess that's what I'm looking for.
    Many thanks!
     

Share This Page

  1. This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
    By continuing to use this site, you are consenting to our use of cookies.
    Dismiss Notice