Trunk Lock Question

DGeoff

DGeoff

Member
Messages
18
Reaction score
4
Location
Canada
Good Afternoon!
I purchased Polaris silver E9 late last year and have been attending to a few minor mechanical priorities and I’m now down to the last bits and pieces.

Which brings me to a trunk lock that won’t lock. I don’t have the key and it seems that Wallothnesch is out of replacement locks.

Does anybody know of an alternative source? I’d also be OK with a non-dimple key type if there is an interchangeable lock from another perhaps more recent model.

I appreciate any guidance.

e9.jpg
 
Thank you!
Here are some snaps attached. I removed the barrel from the lock looking for a code number, but nothing. The washer that pins this lock in place, is also blank.
 

Attachments

  • IMG_8162.jpeg
    IMG_8162.jpeg
    454.3 KB · Views: 37
  • IMG_8160.jpeg
    IMG_8160.jpeg
    427.2 KB · Views: 37
  • IMG_8154.jpeg
    IMG_8154.jpeg
    492.6 KB · Views: 37
you should be able to have a locksmith rekey the lock to match your ignition key / door locks. the lock cylinder can be taken apart without a key. the alternative is to try to buy a set from somebody on the forum with a WTB post in the classified parts section
 
Thanks for the leads. I have seen the lock on eBay but I’m in Canada and, when you add the 25% tariffs plus the normal 12% in sales tax, this expensive lock becomes reallly expensive. Thanks for the link to Koopmans parts list - I’ll for sure reach out to him.
Thanks again!
 
i will look, i think i have one. presumably you are going to have somebody key it to match your car?
500 bucks for a single lock seems a bit userous. 250 for a used one doesn't seem a hole lot better.
 
I am not aware of any interchangable locks. If I understand it well, your dilemma could be solved with a new key? If so, the barrel of the lock carries a stamped number, and I Believe, on your side of the ocean, there are some companies that can cut a key to that code; Santa Monica Lock and Safe, in California is well known and appreciated by various e9 memebrs already:
Here's a link to SFDon's recommendation for them (though the solution was a bit different in that case):

sfdon

Post in thread 'Key replacement/ copy'

Willybaly- Call Blaine at Santa Monica lock and send him a picture of your key.

301 450-5101

He will mail you a new one in about a week.
  • Wow
  • Like

fyi - the FAQ section would have been a good place to start when looking for parts& services: Santa Monica is listed there as well:
1755850047474.png

rsporsche

Post in thread 'What are the TOP SOURCES for PARTS and SERVICE?'

We tend to repeat information within threads, so perhaps it would be a good idea to keep a running list of where to find things. I will be adding more things to this, and editing / adding based on comments.

Restoration

Engine Building
  • Don Lawrence (USA) - SFDon on e9coupe.com
  • La Jolla Independent (USA) -...
  • Like
  • Love
 
Last edited:
You must log in or register to reply here.
Back
Top