http://i260.photobucket.com/albums/ii6/ClassicCoupe/DSCN3337.jpg
If you open the picture you will see the side of the motor that faces the ground. From left to right:
A. brown wire going to the white connector, green leaving
B. green going in red going out
C. tan wire
D. black wire
The question:
The green wire for location A was touching the the brass "spade" but not really connected to it.
1. Is that were this wire belongs?
2. Should I strip more wire and solder it con?
3. What does it do/ activate?
Has anyone got photos of the wires going into the plastic connector showing the wire colors?
If you open the picture you will see the side of the motor that faces the ground. From left to right:
A. brown wire going to the white connector, green leaving
B. green going in red going out
C. tan wire
D. black wire
The question:
The green wire for location A was touching the the brass "spade" but not really connected to it.
1. Is that were this wire belongs?
2. Should I strip more wire and solder it con?
3. What does it do/ activate?
Has anyone got photos of the wires going into the plastic connector showing the wire colors?
Last edited: