mark
Well-Known Member
title says it all. i am in perth.
thanks.
thanks.
wtb a/c fascia and blower
- Thread starter mark
- Start date
krauser
Well-Known Member
A/C Radio plate
Mark,
I have this one in san diego if you are interested(link to flickr photo below), my email is [email protected]
Are you looking for the blower motor for A/C or heater? Do you need the complete blower motor/evap. assembly? More info please,
thanks, Anthony
http://www.flickr.com/photos/34821766@N02/6959890111/in/set-72157623508131090
Mark,
I have this one in san diego if you are interested(link to flickr photo below), my email is [email protected]
Are you looking for the blower motor for A/C or heater? Do you need the complete blower motor/evap. assembly? More info please,
thanks, Anthony
http://www.flickr.com/photos/34821766@N02/6959890111/in/set-72157623508131090
oldcoupe
Well-Known Member
The oldtimerteile part is for an e3, it has one more row of vents than an e9 and sits the radio so low it's unusable.
oldcoupe
Well-Known Member
a/c panel
The E3 one squeezed into my E9 has eight rows, with the top one a dummy blanked off at the back, and a different lip arrangement at the bottom - I counted seven on oldtimerteile's so I assumed it was ok.
My radio, while not actually unusable, is inconveniently low on the tunnel.
The E3 one squeezed into my E9 has eight rows, with the top one a dummy blanked off at the back, and a different lip arrangement at the bottom - I counted seven on oldtimerteile's so I assumed it was ok.
My radio, while not actually unusable, is inconveniently low on the tunnel.
E9 has 6 slats, 7 vents, E3 has one addional slat/vent and bottom lip is slightly different I think. Lots of E9s have E3 panels for some reason.
Believe the Oldtimerteile panel is the correct oem unit for the E9 coupes. It has the same 6 slats and 7 vents as Chris alluded to. Panel on my coupe is also the same. Part # shown in the Oldtimerteile: 51 16 1 811 435 also correlates to the NLA panel.