WTB Complete Body wiring loom for 3.0 CS early 1972

Vern

Vern

Active Member
Messages
54
Reaction score
18
Hahaha...I know wishful thinking, but worth a try.

Also looking for left and right defroster nozzles and hot air hoses.
 
Not sure what your timeline is Vern but I have a defroster vent headed to my modeler to be replacated. I'm going to model the whole vent as well as a vent fix that addresses the part visible from the dash. The whole part will unfortunately cost as much as a good used one. :( The fixit kit should save a lot of vents though.
 
Markos said:
Not sure what your timeline is Vern but I have a defroster vent headed to my modeler to be replacated. I'm going to model the whole vent as well as a vent fix that addresses the part visible from the dash. The whole part will unfortunately cost as much as a good used one. :( The fixit kit should save a lot of vents though.
Click to expand...

Let's see what happens, Markos. This is a long playing project...
 
I have a couple harnesses unlabeled in a bag. Any tell tail differences to identify them?


Sent from my iPhone using Tapatalk
 
If not mistaken I have seen full new reproduction looms on ebay. They come as three parts and all in all add up to about $2000 from what I recall.
 
There is a guy here in Germany that sells/ makes them brand new. Very expensive but available. Front and rear separate. If required, send me a pm and I'll give you the connection. I know the person since years but have no further connection other than that.

Keshav
 
Hi Keshav,
I sent you a PM,
Before I bought my car it was repainted and they got over spray on everything, including the wires under the hood
I can re-wrap them but the connectors would be a problem
They used really good paint, nothing takes it of sort of serious finish remover
 
You must log in or register to reply here.
Back
Top