WTB Complete Body wiring loom for 3.0 CS early 1972

Vern

Active Member
Messages
54
Reaction score
17
Hahaha...I know wishful thinking, but worth a try.

Also looking for left and right defroster nozzles and hot air hoses.
 
Not sure what your timeline is Vern but I have a defroster vent headed to my modeler to be replacated. I'm going to model the whole vent as well as a vent fix that addresses the part visible from the dash. The whole part will unfortunately cost as much as a good used one. :( The fixit kit should save a lot of vents though.
 
seems to me an aluminum one would be an excellent way to go
maybe ill do one for the fun of it.
huge cottage industry.
 
Not sure what your timeline is Vern but I have a defroster vent headed to my modeler to be replacated. I'm going to model the whole vent as well as a vent fix that addresses the part visible from the dash. The whole part will unfortunately cost as much as a good used one. :( The fixit kit should save a lot of vents though.

Let's see what happens, Markos. This is a long playing project...
 
I have a couple harnesses unlabeled in a bag. Any tell tail differences to identify them?


Sent from my iPhone using Tapatalk
 
If not mistaken I have seen full new reproduction looms on ebay. They come as three parts and all in all add up to about $2000 from what I recall.
 
There is a guy here in Germany that sells/ makes them brand new. Very expensive but available. Front and rear separate. If required, send me a pm and I'll give you the connection. I know the person since years but have no further connection other than that.

Keshav
 
Hi Keshav,
I sent you a PM,
Before I bought my car it was repainted and they got over spray on everything, including the wires under the hood
I can re-wrap them but the connectors would be a problem
They used really good paint, nothing takes it of sort of serious finish remover
 
Back
Top