WTB RHD headers

Gazz

Well-Known Member
Site Donor
Messages
945
Reaction score
623
Location
Gold Coast Australia
I know it's a long shot however I need a set of headers / extractors asap.

They need to be larger diameter tubing for a tuned 3.5 ltr transplant and most importantly Right Hand Drive.
 
You have the stock manifolds?
You know I have a set of RHD manifolds
 
Hi Gazz, have you looked at the ones from Fritzbits in the UK, I got a full system and run a 3.5 ( stock for now ) with no problems. They do both headers and full system so you could just get what you need and have the rest made here. I wish that I had done that because I would have plumbed the rear box in from the end rather than the right angle it is now.

Cheers. John
 
Hi Gazz, have you looked at the ones from Fritzbits in the UK, I got a full system and run a 3.5 ( stock for now ) with no problems. They do both headers and full system so you could just get what you need and have the rest made here. I wish that I had done that because I would have plumbed the rear box in from the end rather than the right angle it is now.

Cheers. John

Thanks John. I did contact Fritz but he said I would need larger diameter tubing for my engine which necessitates re-jigging. On the other hand IDB in Melbourne said the standard tubing would be fine. ????
 
I would think a 3.5 engine with cam will be fine with b35 manifolds to b35 down pipes to stock exhaust minus the middle muffler.
A bit over the top on the low end and missing a bit at the top.
Perfect for Australia speed limit laws.
 
sorry Gaz been away ... I will get to meet you when Don comes over .. And Im not going to change my exhaust/headers.. Mine is a CSI...if I was doing a triple webber conversion etc , then I certainly would
 
Back
Top