During dissasembly of my heater control i noticed that the ceremic coil or spool had a connecor that looked fried. Upon inspection, it turns out that a corner of the ceramic material was broken, and because of that, the wires do not line up nicely. Now the control does not move freely anymore.
- update; as I read in another post; it is called a " Variable resistor" and it controls the fan speed.
The part is shown on the attached picture, encircled in green.
below pic, (borrowed from @Belgiumbarry ; thanks) shows the same break that my part had.
Does anyone have this separate part for sale? (Willing to buy a whole assembly if needed, but that seems a bit over the top)
Scammers beware, i will only purchase from known members.
- update; as I read in another post; it is called a " Variable resistor" and it controls the fan speed.
The part is shown on the attached picture, encircled in green.
below pic, (borrowed from @Belgiumbarry ; thanks) shows the same break that my part had.
Does anyone have this separate part for sale? (Willing to buy a whole assembly if needed, but that seems a bit over the top)
Scammers beware, i will only purchase from known members.
Attachments
Last edited: