Vapor Blast/vapor homing Southern California

[Ajay]

Sent my intake manifold, runners, and my throttle body into these guys in Anaheim. They made my parts look like new. They did such an amazing job that I had to post. I know some other e9 and e10 guys in OC use these guys with amazing results. Non abrasive. PARTS REBORN in Anaheim, California.

 

[Bmachine]

Wrong section of the forum but damn that looks mazing.

 

[Stan]

Does a great job! VSR has this as well for us east coasters but only for in-house projects

 

[JayWltrs]

Good explanation: https://www.vaporblastingequipment.com/wet-blasting/what-wetblasting-guide-vapor-blasting-process

 

[teahead]

How much?

 

[jmackro]

Ajay:

Hmm, interesting. Did you need to disassemble that throttle body before having it vapor blasted? Approximately how expensive is the process?

 

[Ajay]

Did not have to disassemble the throttle body and it was less than powder coating the set, which I didn't prefer on my intake. I like the aluminum finish look.

 

[JayWltrs]

Did not have to disassemble the throttle body and it was less than powder coating the set, which I didn't prefer on my intake. I like the aluminum finish look.

Looks fantastic.

Wondering whether you put anything on after to seal or preserve? I recall another thread debating coatings and don’t want to reignite, but if Parts Reborn had suggestions that would be helpful info.

 

[Ajay]

Just used ACF 50. Aircraft anti corrosion spray.