Series II CSL Bat wing

[Motorsport]

I am going through the restoration process of a Series II Bat, as you will tell, it is a bare metal "all in" project. I need the rear wing with the center piece. Any ideas where I may be able to source one? Sadly, I fear that most CSL OEM parts are now cruising around in some restomods.

 

[daddywad]

Hi, I have an original two upright wing that I reproduce and sell complete with rubbber edges. I dont do the 3 upright version I'm afraid. I also make ali bonnets and a colleague makes Scheel repros Mark

 

[Motorsport]

Thank you for sharing, the reproductions look very good. I will share with the shop.

 

[HB Chris]

Didn’t the earliest Series II Bats only have two supports? @BMW Pete will know for sure.

 

[Motorsport]

Hi Chris. I do need advise from the experts! I can tell it is not an early Series II Bat but instead, one of the latest.

 

[e9john]

cckhistoric.com do the rear wing with the central support.

 

[Motorsport]

Thanks John.

 

[aguirola]

We make the rear wing, 2 side supports, no rubber.

100% perfect fit.

Regards, Alberto

 

[Candia4441]

View attachment 138961I am going through the restoration process of a Series II Bat, as you will tell, it is a bare metal "all in" project. I need the rear wing with the center piece. Any ideas where I may be able to source one? Sadly, I fear that most CSL OEM parts are now cruising around in some restomods.

I think you need to talk to Alberto he can make anything with fiberglass he make me a csl bumper and spoiler for me

 

[aguirola]

We make the rear wing, 2 side supports, no rubber.

100% perfect fit.

Regards, Alberto

PS. We also make a tapped ally insert that goes inside the ends of the wing to ensure a positive threading surface.
This is included in the wing, and it is the full width.
If interested, we can also change the angle of attack.
Also, at the bottoms of the the uprights, same ally supports for the trunk mounting location.