Alpine gauge pod

[D Calkins]

Does anyone need an Alpine gauge pod? I'm going to have these cut for me by Send Cut Send. $20 shipped CUSA

 

[rsporsche]

this is the drawing i did (its in the FAQ) where i measured an actual one and did the drawing

 

[rsporsche]

by the way, i have some other VDO series 1 gauges like these if you are in need. i know i have a 100 psi oil gauge and sender, and might have another water temp or another volt ... not sure which.

 

[D Calkins]

Thank you, Scott, for posting that. I used your 2d to create my 3d that send cut send will accept. I will also send anyone the 3d file also. I know that I want an AFR gauge and an oil pressure gauge but not sure after that. I will keep yours in mind.

 

[D Calkins]

I just purchased 4 of these from send cut send. They charged me $58 for 4 bare aluminum 3.2 mm thick.

 

[Rudy3.0CS]

I just purchased 4 of these from send cut send. They charged me $58 for 4 bare aluminum 3.2 mm thick.

I would like on of
Those spare plates!

 

[jhm5]

Can you show me installed photo? I am interested in water temp, oil temp and oil pressure

 

[D Calkins]

 

[D Calkins]

Looks like I have some trimming to in the upper right & left. Does the sheet metal need to be trimmed as well?

 

[TomHom]

....any answer to that question yet?
Does the last pic show the lower edge?
How much clearance at the top?
I am asked to do some with veneer front (like loudspeaker cover). Anybody interested?

 

[D Calkins]

No sir. My assumption is that no metal should be removed

 

[TomHom]

Let's see, I will copy (your consent assumed) and verify. Thanks for your input!
Thomas

 

[D Calkins]

There is very little slop up and down, however there is approximately 2mm of slop left to right

 

[Rouge]

Pour info j'ai réalisé mon support en placage.

 

[Rouge]

Just so you know, I made my stand out of veneer.
Il est juste un peu claire à mon goût.
It's just a little too light for my taste.

 

[jhm5]

Your install looks exactly what I want to do. What gauges did you use?
Anyone have a cad file at SendCutSend for a metal mounting plate or can i use the one at beginning of this thread

 

[D Calkins]

Please send me your email and I will send you the DFX file for send cut send

 

[jhm5]

Thanks

[email protected]

 

[jhm5]

Please send me your email and I will send you the DFX file for send cut send

Is your file same as cutout you have on your Aug 8 posting? Will that be good enough for fabricator?

 

[D Calkins]

Yes, The same file. Download it to your favorite location, then upload at send cut send. You will then be able to see a "snapshot". Select mm