F/S Parts from a 1974 3.0S

[BinksE9]

I have acquired a project that fell by the wayside. It is a 1974 3.0S 4 door sedan. This was a 4 speed car with a sunroof when it left the factory. The motor and trans are long gone. It does still have the diff which I believe is a limited slip. I'm going to remove it and have it gone thru. I have all fenders and doors and most of the trim. A rebuilt wiring harness was included in the car along with Heater and A/C boxes. Also for sale is a NEW carpet kit in Black from World Upholstery. I do have the rear headrests, interior color is dark reddish leather. If interested in any part let me know, it's all for sale and I'm located about an hour east of Sacramento CA. Thanks

 

[Philippe]

Hello Binks,

Are the window channels any good or all dried up?

 

[eriknetherlands]

pm sent

 

[BinksE9]

Hello Binks,

Are the window channels any good or all dried up?

Hi, I will check and let know. Ed

 

[Philippe]

Thank you very much Ed...

 

[mmccusername]

I'm interested in the differential if it's a LSD.

 

[BinksE9]

I'm interested in the differential if it's a LSD.

Hi, I have checked it and it is a LSD. Once removed I will send it to be checked out, the shop is local to me. It is a 3.45 ratio. Thanks, Ed

 

[Ezz]

Hello @BinksE9, do you have the other set of this:

 

[Ezz]

Also, are the door weather seals in good shape?

 

[BinksE9]

Hello @BinksE9, do you have the other set of this:

Hi, I'll be checked those parts today. Let you know after I check them. Ed

 

[Frederick]

I would like this, if it is the firewall drain tube.

 

[Frederick]

That rear windscreen gasket is priceless, if in decent repair.

 

[Frederick]

Hello @BinksE9, do you have the other set of this:

What do you suppose that is? Side draft manifold?

 

[Ezz]

What do you suppose that is? Side draft manifold?

I think these are part of the fuel injection intake
i am looking to convert to FI sometime in the future now that I found a good b35 engine

 

[BinksE9]

I think these are part of the fuel injection intake
i am looking to convert to FI sometime in the future now that I found a good b35 engine

Hi, I did check and yes I have both of those parts. Ed

 

[Frederick]

AH, I am not at all familiar with FI. Was the 3.0S fuel injected? that would make it an Si.

 

[rsporsche]

3.0s was carb'd ... only the Si was injected

 

[CSteve]

A bit off topic, but I had to replace the window felt on all four windows of my '72 Bavaria. Another e3 owner here recommended Steele Rubber Products. They call it "unbeaded rubber channel" but is is felt just like the original. Steele part # 70-3575-58. You will need two rolls. Call to be sure.

My body guy did not want to take the door panels off. He cut as deep as he could into the track. Beautiful job. The old felt is a bear to remove as the factory used some kind of industrial staple to attach them. Worth the effort if yours is falling apart.

 

[Ezz]

Thanks for sharing @CSteve This is for the glass channel/guides, correct?
Any idea if there is an alternative for the doors’ weatherstrips on the E3?

 

[2000CS]

51 32 1 817 560 "clamp" #6 in etk diagram to secure felt channel (#8 on front glass diagram) NLA? Seems like there should be something generic.