Please clarify the terms "Boss" and "Hub" I thought the ribbed metal part was the Hub and the black plastic part is the cover. What is the Boss?
Boss = Hub = Nabe
Please clarify the terms "Boss" and "Hub" I thought the ribbed metal part was the Hub and the black plastic part is the cover. What is the Boss?
Also, how much of the center splined part of the metal ribbed hub should extend past the cover? That is the part of the hub that connects to the steering column, correct?
And then the plastic cover is then close to the steering column top & bottom covers, correct?
Please clarify the terms "Boss" and "Hub" I thought the ribbed metal part was the Hub and the black plastic part is the cover. What is the Boss?
After looking at the wheel on my tii, I noticed the rear of the cover is larger in diameter, about 34.5cm vs the CS of 31.5cm. So, is there one special for just e10?Just under 12mmc about 11.7mm. This is a CS hub (despite the 2002 plunger).
View attachment 109553View attachment 109554View attachment 109555
After looking at the wheel on my tii, I noticed the rear of the cover is larger in diameter, about 34.5cm vs the CS of 31.5cm. So, is there one special for just e10?
Markos, I think I am losing my EnglishHi @merdad,
I’m not following your measurements. The hub cover is nowhere near 34.5cm or 34.5mm. The 2002 Petri is 35cm.
The 2002 hub cover is around 98mm inner diameter at the largest point. It is smaller both in length and diameter than the CS hub cover. In fact it will fit inside the CS cover. See below:
View attachment 109594