Rare: Rear armrests (for Automatic rollers)
- Thread starter Gerrit
- Start date
E9inCostaRica
Active Member
Hello Gerrit do you still have these available?
I think I do but I would have to check. Also have those NOS bits. Please join me at [email protected]
Thanks,Gerrit
Thanks,Gerrit
Attachments
E9inCostaRica
Active Member
Hi Gerrit, that is some good news since I do need those hood blade plastic toppers, please let me know price. On the subject of the armrests I must confess that I already own not one but 2 sets of rear armrests (without the channel guides), nonetheless I have been wanting and searching for the plastic channel guides for the rear seatbelt rollers, so I have a crazy question for you, is there any possibility that those plastic channels could be 3D printed in order to be fitted into my existing armrests? If so how much would you be willing to charge? This is just a question Gerrit if not possible then no worries mate.
If the plastic channels could be reproduced, I would be interested in buying a set as well. Thank you.
Me as well on a 3-d printed option. Not sure if someone has one of these that they are willing to send to me to use a scanner on to then try to print. Shouldn’t be too hard and the the idea would be modifying a current non-channel armrest to hold this piece
Christoph. Bonn
Member
......The entire upper part of the armrest is different, not just the cutout for the additional belt guide.The upper block is smaller.This is necessary for the front belt pulley, which is attached to the wheel arch underneath. There's also an additional cutout on the side for the rear lap belts.
rg, Chris
rg, Chris
Attachments
E9inCostaRica
Active Member
You know what Gerrit having read all info posted here and in other chats, I will just buy the entire armrests from you plus the hood blade platic toppers. let me know package price so that I may pay you via PAYPAL.
Thank you mate.
Thank you mate.
Last edited: