WTB--3 wire clips for front bulkhead

[Drew Gregg]

Here's a pic of them in the engine compartment.

 

[eriknetherlands]

hm, never seen these clips.

What are they supposed to hold? the washer fluid line goes along the hood hinges. The under hood light wire runs along the frontal hinge.

What's left?
Some engine bay pic's in this thread, none of them show these clips there.

Thread 'show your ...engine'

Oct 10, 2016

i will start this series of "show your ..." with the engine area

i think a catalog of the different areas of the coupes might be very valuable to others that wanted to know where to start a restoration, alternatives, possibilities, ideas,...

there are plenty of threads asking about a radio setup, how seats look like,...

so lets see if we can cover the whole car

please add a little description of the car, year, model, variations,...

• deQuincey
• Replies: 76
• Forum: E9 Photos

• 

 

[boonies]

I think the wiring to the primary side of the ignition system (ballast resistor & coil) and also the wires to/from the AC compressor to electric fan in front of the condenser if equipped.

 

[Stevehose]

Yes as Lance mentioned they hold the wiring harness that goes across underneath from battery area to ignition/ac etc

 

[Fritzie]

Cable clamp D=12MM for all models and all years of manufacturing

Cable clamp D=12MM for all models and all years of manufacturing

www.wallothnesch.com

But I prefer to use something plastic like this. https://www.wallothnesch.com/en/set...ring-15-pieces-various-length-61-06-09-1.html
Because the steel scratches the paint.

 

[Fritzie]

Some pictures and original numbers #4

 

[Fritzie]

And you can spot them also in this car

 

[Krzysztof]

Metal "finger" can be covered with thin shrinkable tube but also modern solution can be used:

or

 

[Drew Gregg]

Cable clamp D=12MM for all models and all years of manufacturing

Cable clamp D=12MM for all models and all years of manufacturing

www.wallothnesch.com

But I prefer to use something plastic like this. https://www.wallothnesch.com/en/set...ring-15-pieces-various-length-61-06-09-1.html
Because the steel scratches the paint.

These are the correct clamps that are used per Steve's post. I used tie wraps behind the grills and over the condenser to hold up the wiring. Seeing those 3 holes made me look for why they were there.

 

[alprada70]

I bought them but wasn't sure exactly where they go, thanks!