WTB: shift knob emblem 25 11 1 220 956

Christoph. Bonn

Christoph. Bonn

Member
Messages
28
Reaction score
48
Location
Bonn, Germany
Hi everyone,
I am looking for the shift knob emblem, part number 25 11 1 220 956 (30mm diameter).
It is crucial that the surface is made of hard plastic.
New Old Stock (NOS) would be ideal
(There are reproductions available with a soft silicone surface, but those are unsuitable.)
This emblem has long been unavailable in the EU, and I would like to start producing new shift knobs again. :)
Thanks for your help, Chris

Kopieren von Kopieren von 20230119_143501.jpg
 
I think this is hard plastic?
 

Attachments

  • IMG_7242.jpeg
    IMG_7242.jpeg
    450.7 KB · Views: 30
  • IMG_7243.jpeg
    IMG_7243.jpeg
    352.4 KB · Views: 27
  • IMG_7244.jpeg
    IMG_7244.jpeg
    403 KB · Views: 26
Chris… can’t help with the emblem…but if you decide to make some plain rounded top ones like the original… I’m in.
 
Thanks for the tip, but take a look at my picture
vs
the motorcycle logos;
the differences are in the:
size
surface finishouter
silver ring around the outside !!
(which isn't present on Stefan's logos either)

So, it’s either 100% right, or there will just be wooden knobs without logos.
best, Chris
 
It is not - we know that. :)

Hard plastic can be trimmed by sanding and polishing.

For me the best would be to case them new - not impossible on silicone based casts.

For ideal fitting only OE NOS will do the job I would like to have - no doubts about that!
 
Exactly, that's what I mean by 100%. :cool:

And since I no longer have any gear shift knobs—but want to go back to that standard—I am now looking for the emblems. :-))
 
Did you want me to send it?

Are you trying to buy a quantity or do you just need one to do a reproduction?
 
You must log in or register to reply here.
Back
Top