3.0cs & Bavaria drive axle output half shaft

[2k2tii]

Brand new, OEM BMW

2 drive axle output half shafts


fits the following:



*3.0cs

*Bavaria

*3.0csi

*2800

*3.0s

*2500

*2800cs



part # 33211102423



2 retail for $1244.97 (see last pic)



$900 + shipping

 

[dp]

Welcome to the board! Since you've no introduction, I'll just start right in with a couple questions

There was a single one of these on eBay forEVER for like 100 bucks, did you buy it?

And ... are you selling one, or two?

--dp

 

[Stevehose]

Welcome, I was the one who bought the NOS E-brake handle from you recently

 

[dang]

And ... are you selling one, or two?

Updated to show two for sale. Although expensive, Connor has a good reputation on other BMW boards.

 

[Gary Waggoner]

I just threw 2 in the dumpster.

 

[2k2tii]

I just threw 2 in the dumpster.

And those were used.

These are brand new.

 

[HB Chris]

Regardless of list price, I don’t think you will find a buyer at your asking price since they can be rebuilt for around $200.

 

[deQuincey]

i only have one little thing to ask
my understanding was that the coupe and the bavaria had different lengths of these cv joints
the e9 ones were shorter than the e3 ones
just bear it in mind

 

[dang]

i only have one little thing to ask
my understanding was that the coupe and the bavaria had different lengths of these cv joints
the e9 ones were shorter than the e3 ones
just bear it in mind

Hmmm, I guess this would explain why you never hear about people swapping an E3 rear subframe to an E9. I actually didn't know that E3's came with rear discs until I bought one. Are the rest of the rear suspension parts different also? (thread hijacking in progress)

 

[deQuincey]

Hmmm, I guess this would explain why you never hear about people swapping an E3 rear subframe to an E9. I actually didn't know that E3's came with rear discs until I bought one. Are the rest of the rear suspension parts different also? (thread hijacking in progress)

well i am not an expert in the e3, and the last thing i would like to contribute is to ruin a FS thread
there are a couple of points to mention looking at the pictures,
these parts look superb
there is a card in which you can read coupe
they seem to me to be the short type aka e9 parts
as to the asking price everything is relative, different people different perspectives maybe
GLWS

 

[Bavman]

Bavaria and CS have different axels.
The subframes are the same (Moderator Edit 07/23: subframes are not the same)
The rear arms, hubs, stubs may be different, there are differences thru the range of e3, 9, 12, 24 and New Class.

Example, if you put CS rear arms complete to get vented disc on a Bav. you would change the rear track a tad...but you may be able to run something like a 9 inch wide wheel if you were careful with the offset.

Bavaria’s and CS’s are easy compared to figuring out what fits what New Class....good luck to whoever inherits my 2000tilux race car.


Oh, good luck with the sale.

Alonzo